Using The Device - Indel B FM7 BACK Instrucciones De Uso

US IN G THE D E VICE
Attention
Before the first start-up of the device, clean the inside with water and neutral detergent and dry
with a soft cloth.
Attention
The compressor of the cooling circuit starts approximately 60 seconds after the device has been
started.
E N E RGY-SAVI N G TI P S
• Place the device in a well ventilated place protected from sunlight.
• Do not open the device door more often than required: every opening generates a change
in the internal temperature and causes the build up of ice.
• Do not leave the door open longer than required.
• Defrost the device at regular intervals, however as soon as the ice layer can be seen.
D E FRO S TI N G TH E D E VI C E
Inside the device or in the refrigerated compartment, or on the evaporator, frost
can build up due to humidity, that reduces the capacity of refrigeration. Periodically defrost the
device, as early as possible to prevent the reduction of the capacity of refrigeration.
Proceed as follows for the regular defrosting of the device:
• Remove the products stored inside and place them into another refrigerator, so that
storage temperature can be ensured.
• Open the door of the device to melt the layer of ice.
Attention
Do not use hard and/or sharp objects to remove the layer of ice and release the frozen products.
• Dry condensation with a soft cloth and close the door.
35