Setting The Time - Indel B K ECOSMART PV BLACK Serie Instrucciones Para El Uso

K ECOSMART PV BL ACK
SETT I N G T HE TIME
If you press any button from P1 to P4 several times, the display will show the chosen programme and
then the time.
To set the time, press P2 and P3 at the same time. The hour digits will start to flash and the display will
show the words "set time".
Press - (P2) and + (P3) to set the right time.
To set the minutes, press P1 and then - (P2) and + (P3).
Press P4 to save the new time setting. The display will show the
current time.
To set a programme (P1, P2, P3 or P4) on the Minibar, press the but-
ton of the chosen programme for at least 2 seconds.
If the batteries have run out, the display will show this symbol:
Press ON/OFF to turn the Minibar off. The display will show "Off". To
enable the remote control again, press the ON/OFF key.
ATTENTION!
If the mains power supply is cut off for less than 48 hours, the Minibar
turns on again using the previously set program. If the mains power supply is cut off for more than 48
hours, the Minibar will be operated by the pre-calibrated thermostat. To set a program again, follow the
instructions given on THE REMOTE CONTROL.
ATTENTION!
If the power supply is voluntarily cut off, wait at least 15 minutes before turning the refrigerator on again
(i.e. before connecting it to mains supply). If not, the compressor could be locked for few minutes before
starting its normal operating.
K ECOSMART PV BLACK_IM_20220512
30
SET TIME
TIME
OFF