Technical Data; Fuel Specifications - Truper SOPLA-26T Instructivo

Technical Data

Description
Air Speed
Air Volume
Maximum Motor Speed
Idle Speed
Fuel Tank
Work Cycle

Fuel Specifications

• The blower is built with an air-cooled, 2-stroke engine using unleaded gasoline and high-quality auto-mixing oil with fuel
stabilizer specified for air-cooled, 2-stroke engines.
• The motor is certified to run with unleaded gasoline for vehicles with octane rating 87 ([R+M]/2) or higher.
• Do not use any type of pre-mixed gasoline with oil sold in service stations, especially for motorcycles, etc.
• Do not use engine oil for self-propulsion, or two-cycle oil outboard motor.
• The ratio in the mix shall be 40 parts of gasoline per 1 part oil (40:1 ratio). Prepare the mix in a container approved to store
gasoline. Always mix thoroughly before pouring into the motor tank.
Do not use gasoline mix that has been stored for more than 7 days. Mix small amounts.
CAUTION
Never smoke in the vicinity of the fuel or the filling up area, or where the mix is being prepared,
WARNING
or when operating the blower.
Trying to start the blower without adding oil into the fuel mix will cause the motor to malfunction.
WARNING
Using the ACT-2T-4 and ACT-2T-16
per each liter gasoline.
1
L
1 liter
Gasoline
To increase the working life or the motor use
Code
Motor
Power
Weight
30 minutes rest per tank consumed. Maximum 6 hours daily
A wrong mix may cause the motor to throw
a rod causing expensive repairs!
+
5 capfuls oil
SOPLA-26T
13047
Gas Blower / Vacuum
26 cc
1 Hp
180 MPH
353 CFM
8000 RPM
3000 RPM
15,5 oz
9,7 lb
Oils** cap as measure, mix 5 capfuls oil
=
40:1
synthetic oil for 2-stroke motors.
* 1 gallon = 3,78 liter
ratio
Mix
** Not included
ENGLISH
3