Start Up; Turning Off - Truper SOPLA-26T Instructivo

Start up

Start Up with a Cold Motor
A
• The blower shall be placed on a flat and clean surface.
• Set the two handle switches (A) in the On position ( I ).
• Press the primer bulb 6 times (B). Fuel shall be visible
inside the primer bulb. Otherwise, keep on pressing the
primer bulb until fuel can be seen inside the bulb.
• Move the starter choke lever (C) into the "| | Start"
position.
• Lightly pull the jack-line (D) until feeling resistance. Pull
quickly 3 or 4 times. Usually, the motor will not start in
this step.
• Move the starter choke lever into the "| | Run"
position. Pull the jack line one more time to start the
motor.
C
D
Start Up with a Hot Motor
• The blower shall be placed on a flat and clean surface.
• Set the two handle switches (A) in the On position ( I ).
• Set the starter choke into the "| | Run" position.
• Pull the jack-line until the motor starts.

Turning Off

• Press any of the switches into the ( STOP ) position to
stop the motor.
B
x6
8
ENGLISH