General Information; Kit Components; Mounting The Handset - Extel WEPA 201 LC Guía De Instalación Y Utilización

ENGLISH

GENERAL INFORMATION

This integral 2 wires door phone enables controlling a strike or an
automatic gate opener* from the roadside panel.
(*in this case plan to order the WE 8111 Bis option)

KIT COMPONENTS

•An internal handset • A roadside panel with an electroluminescent
nameplate • A 230 VAC / 15 VDC - 1000 mA mains adaptor.
MOUNTING THE ROADSIDE PANEL
•Release the 2 screw caps (A) with a small flat screwdriver• Remove
the 2 attachment screws (B) • Feed the wires from the handset and the
gate opener through the hole (C) • Fix the rear frame with 2 screws
(E) on the pillar at a height of approximately 1.60m. Important : Put a
silicon gasket on the upper half between the support of the
roadside panel and the wall.(D)• Access to the nameplate by the rear
of the panel. Remove the nameplate applying a light pressure on the
sides of the call button support. • After having written the name, put
back the call button in its original position•Connect the wires of the
roadside panel as indicated on the wiring diagram • Put back the front
*
panel of the roadside panel with the 2 screws (B) •Replace the 2 screw
caps taking care of putting the one with the hole (G) at the bottom.
If you order an automatic gate opener, plan to order the we8111 option.
*

MOUNTING THE HANDSET

• Fix the attachment screws on the wall, respect the 16.5 cm
centre distance between the 2 attachment screws. Note the
handset must be placed at approximately 1.60 m from the ground.
•Connect the wire 1 of the roadside panel on the terminal 8 of the
handset • Connect the wire 2 of the roadside panel on the
terminal 7 of the handset • Connect the plug of the power supply
transformer to the back of the handset • Mount the handset to the
wall •Plug the power adapter into the 230 VAC wall socket.
If the power supply cord is cut, respect polarity.