Master audio XCELLENCE SERIE Manual Usuario página 15

Master Audio
The connection panel has the following parts:
F) NETWORK: Computer connection through Ethernet protocol. Two 8-pin RJ45 /
EtherCon® compatible connectors with an internal switch allow the connection of
several units in daisy-chain. Please refer to Master Audio DSPStudio Quick Installation
Guide for more information on the remote connection.
G) BALANCED INPUT/LINK:
XLR-3 Female balanced signal connector for signal input.
XLR-3 Male connector for parallel connection of various cabinets with the same input
signal.
IMPORTANT: Please always use balanced microphone cable with the following pin
assignment:
1= Shield (Ground) 2= Live (+)
A
Fig.8. X18WE control and connection panel
H) AC INPUT/OVERVOLTAGE PROTECTION: These leds show the status of the
AC mains supply.
 ON: (Blue) When lit, the equipment is ON and the AC input level is within the
permitted range (up to 250 VAC).
 STANDBY: (Orange) This led is lit when the equipment is sensing the AC
voltage at the input. At power-up this led will lit for a second while the systems
checks for the input voltage.
 >250V OVERVOLTAGE PROTECTION: (Red) When activated, the AC
voltage is permanently out of the permitted range of the equipment
(>250VAC), so it will remain under protection until this condition is solved.
Revise your connections and mains power installation and consider that other
equipment connected to this line may have been damaged.
Xcellence "E "Series. Ver1.0
3= Return (-)
B
F G
E
C D
H I
Nov12
15