Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2 - INSTALLATION INSTRUCTIONS
SOL-P2
SOL-D
2.1
INSTALLATION RECOMMENDATIONS
During installation, or in the case of maintenance,
carefully follow the instructions outlined in this manual.
Changes of any connections or the non-compliance with
these
instructions
will
warranty.
Use original spare parts supplied by the manufacturer.
2.2
PACKAGING
The device is delivered packed in a cardboard box with
appropriate protection.
Inside is an envelope containing this booklet and the
warranty certificate.
PACKING
DIMENSIONS
SOL-M
48x49x214 cm
SOL-S
35x35x224 cm
SOL-N
35x35x224 cm
SOL-P3
35x35x224 cm
SOL-P2
25x25x224 cm
SOL-D
35x35x224 cm
Fig. 1.6-5
Fig. 1.6-6
immediately
invalidate
WEIGHT
WITH
PACKING
65 Kg
15 Kg
12 Kg
10 Kg
7 Kg
7 Kg
2.3
SIZING
In order to determine whether the facility is well
proportioned and not undersized, one must take into
account
the
installation.
Here below are some useful tips:
position the shower time sunny area and not shaded
within a high insolation day, the M model is capable
of providing up to 240 liters of hot water at the
temperature of use, the SN models over 120 liters,
the P3 model about 50 liters, the P2 model about 35
liters and D models about 40 liters
2.4
POSITIONING THE MACHINE
The accumulation solar shower must be installed so
that it is always exposed to the sun's rays and given its
circular shape, he is able to pick up the same from any
position; however the ideal orientation of the solar
shower is toward south.
IMPORTANT
The shower only and exclusively be mounted in a
vertical position in order to promote stability.
With regard to SP models, to optimize the yield is
slightly tilted the device in such a way that the rays are
as perpendicular as possible relative to the shower
body.
In
fact,
the
stratification of water and, since the sampling occurs in
the upper part, it has a better use of all the hot water.
IMPORTANT
The MSN models predict a coating methacrylate and
the
it is therefore necessary to pay close attention
during their handling.
In particular, the displacement of the lifting showers
must proceed only from the base or from the top
avoiding to grasp the outer coating methacrylate (see
Fig. 2.4-2, Fig. 2.4-3, Fig. 2.4-4, Fig. 2.4-5).
This is because, being a very brittle material, there is a
risk of obtaining cracks or breakages of the same
methacrylate which should be such as to affect the
proper functioning of the appliance and yield.
needs
and
some
precautions
inclination
of
the
same
during
Fig. 2.4-1
promotes
Publicidad
Tabla de contenido
