General Warnings; Safety Components; Intended Use - ATI SolarJet SOL-M Manual De Instrucciones

1- GENERAL INFORMATION AND FEATURES
1.1

GENERAL WARNINGS

This manual is an integral and essential equipment and
should be delivered to the user. It should be stored
carefully and consulted
important information on the safety of operators, for the
operation and for proper maintenance. In case of doubt
or for more information in the manual, contact the
manufacturer.
The appliance must only be used for which it was
intended. Any other use is considered improper and
therefore dangerous.
And 'it is excluding any non-contractual liability of the
manufacturer for damages caused by errors in the use
and installation of the appliance, or failure to comply
with the instructions provided by the manufact urer.
IMPORTANT
The manufacturer reserves the right to modify the
product and its technical documentation without
incurring any liability to third parties and assumes
no responsibility for any errors or imprecision in the
content of this booklet. The present drafting of the
manual for the use and maintenance describes the
characteristics about the appliance of the series the
date on which this publication is fired for printing.
1.2 MANUFACTURER
The manufacturer is available to technical problems or
for ordering spare parts.
For any communication
recommend to always provide the following information:

product type

serial number (serial detectable label)

period of manufacture (detectable label serial)

date of purchase (receipt or invoice copy)

Detailed information about problems found
IMPORTANT
To replace some components we recommend the
use of original spare
declines all responsibility for any deterioration of
the device performance for damages caused to it
due to the use of spare parts not original.
1.3

INTENDED USE

Solar energy is a good thing not to be overlooked, as it
is a real alternative to the increasingly alarming energy
crisis.
Sensitive to these new requirements, was produced this
equipment can provide hot water from solar energy,
directly on the site where it is installed.
In fact the product:

it is environmentally friendly because it does not
produce any smoke or polluting waste

is simple because it can be installed at any place
and does not need other components such as
accumulators, pumps, controllers, electricity, etc ...

it is patented for its high yield and its aesthetic
characteristics
The solar shower has a cylindrical shape. Its r educed
dimensions, in relation to the amount of water contained
and the absence of electromechanical components
make, by adopting a few tricks, extremely practical to
install.
This product is manufactured with materials specifically
designed in order to obtain on the one hand the
maximum uptake of the solar rays, on the other hand
the resistance to atmospherical agents, completely
carefully, as it contains
device purchased,
parts; the manufacturer
eliminating maintenance costs and ensuring maximum
yield.
1.4

SAFETY COMPONENTS

Safety valve and check valve
The MSN models are equipped with a safety valve (1)
and provided with the solar shower. This has the
function of
overpressures due to the increase of the water volume
when it is heated; also prevents the same to return to
the cold water circuit.
IMPORTANT:
retention but only serves to prevent the mixing of
hot and cold water. If the hydraulic system type
requires it is necessary to install a total check
valve.
The possible absence of the same void the warranty
on the tank.
IMPORTANT: This valve is not present on P3 -P2-D
models as unnecessary.
we
Flow Reducer
The P3-P2-D models provide for the insertion of a flow
reducer. This is screwed into the sleeve for connecting
the water pipeline.
IMPORTANT: It is critical that this flow limiter, which
can cause permanent damage to the shower, never
to be removed. In the event that, for whatever
reason (cleaning, etc.) Were to be unscrewed,
remember to
reconnecting the water attack.
preserving the tank
Fig. 1.4-1
the safety valve is
Fig. 1.4-2
reposition it in its
from possible
not to total
seat before