Marantz professional PMD-500D Guia Del Usuario página 13

To create a Program (a list of tracks that will play in a specific order):
1. Press Prog on the remote control. The Program page will appear on the screen, showing the 20
available slots of the Program (10 on each page).
2. Press OK or the Play/Pause (
Program (highlighted).
3. Use the number buttons (0–9) to enter the desired track with two digits (for example, enter 0, then 4,
to select track 4). Once two valid digits have been entered, the program will move to the next available
slot.
4. When finished, use the cursor buttons to select Start, and then press OK or the Play/Pause (
button to begin program playback.
5. You can also do any of the following in the Program page:
• Press the Skip Back/Forward (
and tracks 11-20.
• If the current slot of the Program (outlined in yellow) contains a track number, press Clear on the
remote control to clear that slot.
• Use the cursor buttons to select Exit, then press OK or the Play/Pause (
Program mode. All selections will be cleared.
While viewing the Program page, you cannot use any buttons (on PMD-500D or the remote control)
other than the ones described above.
A bookmark is a specific location in an audio track that is stored in PMD-500D's memory. You can set up
to 12 bookmarks and then jump to those locations directly, saving you the time of scanning through the
audio later.
To create a bookmark,
1. Press Mark on the remote control at the desired location during audio playback. The bookmarks will
appear on the screen.
2. Use the left/right cursor buttons () to move through the bookmarks. The bookmarks you have
created are will show a number, and unused bookmarks will be blank.
3. Press OK or the Play/Pause (
To cancel the operation, press Mark.
To jump to a bookmark:
1. Press Mark on the remote control. The bookmarks will appear on the screen.
2. Use the cursor buttons to move through the bookmarks. The bookmarks you have created will show
a number, and unused bookmarks will be blank. When you select a used bookmark, you will see the
current track and current time below it.
3. Press OK or the Play/Pause (
that bookmark's location.
To cancel the operation, press Mark.
To erase a bookmark:
1. Press Mark on the remote control. The bookmarks will appear on the screen.
2. Use the left/right cursor buttons () to move through the bookmarks.
3. Press Clear to erase the desired bookmark.
4. Press Mark to close the bookmarks and return to normal playback.
) button on the remote control to "unlock" the current slot of the
/ ) buttons to switch between viewing program tracks 1-10
) button to save the bookmark.
) button to jump to the desired bookmark. Playback will resume from
)
) button to exit
13