Página 1
F35b INSTRUCTION MANUAL We’ll Make It Stress-Free If you have any questions along the way, just give us a call. 1-888-333-9952. We’re ready to help! Scan for easy install video san.us/249...
IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE Before You Begin Please check the following items: Your TV and any accessories you plan to use do not exceed the specifi ed weight limit. The hole pattern on the back of your TV is compatible with the hole pattern of the TV brackets.
Página 5
Supplied Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer;...
Página 6
Parts and Hardware for STEP 2 Parts and Hardware for STEP 1 Cont. Wall Plate Wall Plate Template Washers M4/M5 M6/M8 Spacers Washers Lag Bolts 5⁄16 2 3⁄ 4 5⁄16 Concrete Anchors...
Página 7
STEP 1 Select TV Hardware and Attach Interface Brackets to TV Hand thread screws into the threaded inserts on the back of your TV to determine the correct screw diameter (M4, M5, M6, or M8). Determine what kind of TV you have and if you require extra space between the wall and the TV to accommodate cables. •...
Página 8
STEP 1-A Ensure that your brackets are level on the back of the TV. If you need extra space to accommodate cables, recesses, or protrusions; use spacers (see the irregular back option on the next page). 04 05 06 IMPORTANT: After attaching the brackets, adjust the straps so they are level with the bottom of the TV.
Página 9
STEP 1-B Ensure that your brackets are level on the back of the TV. Standard confi gurations are shown. For special applications, or if you are unsure about your hardware selection, contact Customer Service. 11 12 07 08 09 10 IMPORTANT: After attaching the brackets, adjust the straps so they are level with...
Página 10
STEP 2 Attach Wall Plate to Wall - Wood Stud Option Locate your stud(s). Verify the center of the stud using an awl, a thin nail, or an edge to edge stud finder. CAUTION: Avoid potential personal injuries and property damage! ●...
Página 11
STEP 2 Drill pilot holes. IMPORTANT: Pilot holes must be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit. Tighten the lag bolts only until the washers are pulled firmly against the wall plate CAUTION: Improper use could reduce the holding power of the lag bolt.
Página 12
STEP 2 Attach Wall Plate to Wall - Solid Concrete or Concrete Block Option Level the wall plate template and mark the hole locations. CAUTION: Avoid potential personal injuries and property damage! ● Mount the wall plate directly onto the concrete surface ●...
Página 13
STEP 2 Insert anchors CAUTION: Be sure the anchors are seated flush with the concrete surface. Tighten the lag bolts only until the washers are pulled firmly against the wall plate CAUTION: Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
Página 14
STEP 3 Attach TV to Wall HEAVY! You may need assistance with this step. IMPORTANT: You will hear an audible click when the TV bracket is securely fastened to the wall plate.
Página 15
Troubleshooting ADJUSTING THE TILT: Loosen the knob on the ADJUSTING THE LEVEL: If needed, tighten REMOVING THE TV: Pull down TV bracket to adjust the tilt of your TV. Tighten one of the screws on the top of the TV bracket on the straps and lift the TV up the knob when your TV is set to the desired tilt.
ESPAÑOL INSTRUCCIONES DE SEGURIDAD IMPORTANTES. CONSÉRVELAS. LEA TODO EL MANUAL ANTES DE UTILIZAR ESTE PRODUCTO. Antes de comenzar Cerciórese de: que su televisor y los accesorios que planifica usar no excedan el límite de peso especificado; que el patrón de orificios de la parte trasera de su televisor sea compatible con el patrón de orificios de las placas de sujeción para el televisor;...
ESPAÑOL Piezas y elementos de sujeción suministrados ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor;...
Página 18
ESPAÑOL PASO 1-B Asegúrese de que las placas de sujeción quede nivelada en la parte posterior del televisor. Se ilustran las configuraciones estándar. Si desea información sobre aplicaciones especiales o si tiene dudas sobre la selección de piezas, contáctese con el servicio de atención al cliente. IMPORTANTE: Luego de fijar las placas de sujeción, ajuste las correas para nivelarlas con la parte inferior del televisor.
ESPAÑOL ● Tamaño mínimo del bloque de cemento: 203 x 203 x 406 mm (8 x 8 x 16 pulgadas) ● Espacio horizontal mínimo entre los dos sujetadores superiores: 120,6 mm (4¾ pulgadas) Realice los orificios guía. IMPORTANTE: Los orificios deben realizarse con una mecha de 10 mm (3/8 pulgada) de diámetro, hasta una profundidad de 75 mm (3 pulgadas). Nunca perfore el cemento que une los bloques.
Página 20
Thank you for choosing Sanus VuePoint! Please take a moment to let us know how we did: Call us: 888-333-9952 Email us: info@sanus.com Leave a review: vuepoint.sanus.com UK: 0800 056 2853 Milestone AV Technologies and its affi liated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations.