Adjusting The Nail Penetration; Adjusting The Direction Of The Exhaust; Clearing A Jam From The Nailer - Campbell Hausfeld NB0064 Manual De Instrucciones

Operating Instructions
Operating The Nailer
(Continued)
2. Pull pusher (B) back until the nail
follower falls behind the nails. Insert
strip of nails into rear of magazine
(A).
(B)
(A)
3. Do not load with the safety or trig-
ger depressed.
4. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except always disconnect the air
hose before unloading.

ADJUSTING THE NAIL PENETRATION

The NB0064 is equipped with an
adjustable depth of drive feature. This
allows the user to determine how deep
a fastener will be driven into the work
surface.
1. Adjust operating pressure so nails
are driven consistently. Do not
exceed 110 psi.
2. To drive the nail shallower, turn the
wheel (C) to right to the extent
desired.
(C)
3. To sink a nail deeper, turn the wheel
(C) to left to the extent desired.
4. Make sure trigger
and work contact ele-
ment (WCE) move
freely up and down
without binding or
sticking after each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The NB0064 is
equipped with an
adjustable direc-
tion exhaust
deflector. This is
intended to allow the user to change
the direction of the exhaust. Simply
twist the deflector to any direction
desired.

CLEARING A JAM FROM THE NAILER

1. Disconnect the
air supply from
the nailer.
2. Remove all
nails from the
magazine (see
Loading/
Unloading).
Failure to do so will cause the nails
to eject from the front of the tool.
3. Undo latch by
pulling out and
down. The wire
latch will disen-
gage from the
hooks on the nose.
4. The door can
now be rotat-
ed, exposing
the jammed
fastener.
5. Remove the
jammed fasten-
er, using pliers
or a screwdriv-
er if required.
5
6 Rotate door
back into the
closed position.
7. Extend the
wire latch and
place over the
hooks on the
nose.
8. Close the latch
Rotate by pushing the
latch up and in
until the latch
snaps into
place.
9. Make sure the
trigger and
work contact
element (WCE)
move freely up
and down without sticking or bind-
ing.
Technical Support
Please call our Nailer Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this nailer or
for additional copies of this manual.
Fastener And Replacement
Parts
WARNING
!
Hausfeld 16 gauge fasteners (or equiv-
alent - see Fastener Interchange
Information). Tool performance, safety
and durability could be reduced if
improper fasteners are used. When
ordering replacement parts or fasten-
ers, specify by part number.
Nailer Repair
Only qualified personnel shall repair
the tool and they shall use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and acces-
sories which perform equivalently.
Model NB0064
movement
Use only
genuine Campbell
www.chpower.com