Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – PFS Perimeter Fence Shield
Overview
The PFS is a versatile house side shield option compatible
with all optical distributions, designed for field installation to
address spill light issues. Measuring 2" high and 6" long,
the PFS is available in black and features 4 horizontal sec-
tions and 4 vertical sections for cutting if adjustments are
needed. Each section measures 0.5" high x 1.25" long.
Horizontal angles of occlusion, measured perpendicular to
the shield from the farthest LED are as follows (FIG 1):
No adjustment: 25°
Remove one horizontal section: 20°
Remove two horizontal sections: 14°
Remove three horizontal sections: 8°
A single PFS is designed to eliminate spill light from one
side of a single square. Where multiple squares are used,
each square will require a PFS kit to fully shield the light
square and provide adequate stability for the shield.
Each PFS kit includes 4 shields and 4 screws. One kit
recommended per light square.
Installation Instructions
Tools Required:
Phillips head screwdriver
Utility snips (optional)
1.
Before installing, calculate the shield dimensions
needed, adjusting the height or width by cutting along
the grooved sections (optional). (FIG 1)
2.
Remove the four screws which secure the light square
and trim ring to the fixture.
3.
Remove the trim ring and place the PFS shield over the
light square where required. (FIG. 2)
4.
Where multiple shields are needed on the same light
square, ensure the tabs overlap correctly for a secure
fit. (FIG 3)
5.
Fasten the light square and shield(s) in place with the
screws provided. (FIG. 4)
2
EATON
IB500014EN
Installation instructions
0.5"
Figure 1.
Figure 2.
Figure 3.
Figure 4.
25˚
20˚
14˚
8˚
Publicidad
