Publicidad
Caution! Laser radiation�
Movement direction�
Rotation direction�
Short pressing�
Long pressing�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Do not dispose of the appli-
ance in a domestic waste
container�
Intended use
The appliance is designed to measure
distances using a laser beam� It can
be used to measure linear dimen-
sions, calculate the area and volume,
and also perform indirect measure-
ments�
[CT44032,
CT44033,
CT44035]
These models have a built-in tilt sen-
sor to measure angles�
Components
1 LCD display
2 Laser beam output hole
3 Receiving lens
4 Housing
5 Button "On / Measure start"
6 Button
7 Button "Plus"
8 Button "Reference point selection"
9 Button "Off / Results reset"
10 Button "Minus"
11 Button
12 Button "Laser beam on"
13 Sign
14 Sign "Area / Volume measure-
15 Sign "Indirect measurements"
16 Sign "Battery charge"
17 Button "Measurement unit"
18 Sign "Selected reference point"
19 Sign "Maximum value"
20 Sign "Minimum value"
21 Sign "Appliance tilt angle"
22 Sign "Memory"
23 Sign "Measurement values addi-
24 Sign "Measurement value"
25 Button "Plus / Minus / Memory"
26 Bubble level
27 Button
28 Battery case cover
29 Battery (1�5 V, AAA type) *
* Optional extra
Not all of the accessories illustrated
or described are included as stand-
ard delivery.
CT44034,
Installation / regulation
Installing batteries (see fig. 1-2)
•
•
polarity�
•
•
is indicated by sign 16, and display 1
shows the "Err10" error code�
English
26
"Measurement
selection"
"Measurement
Memory"
"Continuous
ment"
ment"
tion / Subtraction"
"Measurement
Measurement mode"
Remove cover 28 (see fig. 1-2).
Install batteries 29, observing the
Replace cover 28�
The need to replace batteries 29
mode
units
/
measure-
units
/
Publicidad
