Tabla de contenido
Publicidad
•
Press and release button 5 to meas-
ure the width�
Display 1 will show the measured
•
length / width and the calculated
area�
Volume measurement (see fig. 8, 19)
•
Turn on the appliance�
•
Press and release button 27 or 6
(depending on the model) to enter the
volume measurement mode� Display 1
will show sign 14 (see fig. 8, 19). There
are flickering symbols around sign 14;
they show which of the three distances
should be further measured�
•
Set the appliance in the measure-
ment starting point�
Press and release button 5 to meas-
•
ure the length�
•
Press and release button 5 to meas-
ure the width�
Press and release button 5 to meas-
•
ure the height�
•
Display 1 will show the measured
length / width / height and the calcu-
lated volume�
Indirect
measurements
fig. 9, 20-22)
•
Turn on the appliance�
Press and release button 27 or 6
•
(depending on the model) to enter the
area measurement mode� Display 1 will
show sign 15 (see fig. 9, 20-22). Parts
of sign 15 will flicker to show the dis-
tance to be measured further�
•
Take measurements as shown in
figures 9, 20-22. The arrows with num-
bers show the sequence of measure-
ments� The distance to be measured is
indicated with "x"�
The manufacturer reserves the possibility to introduce changes.
Maintenance
Error codes (see fig. 13, 26)
When the appliance is operated,
•
the display may show the error codes
that mean the following:
Err10
•
discharged - replace them�
Err15
•
measured is outside the measurement
range - aim the beam more accurately,
or measure the distance in parts�
Err16 - the received signal is
•
too weak - use a special light target
(accessory), ensure that the appliance is
immovable when taking measurements�
•
Err18 - the received signal is too
strong (the surface reflectivity is too
strong) - use a dark target (accessory)�
Cleaning the appliance
•
Keep the appliance clean� Do not
use caustic substances or solvents�
•
Remove contamination from the
laser beam output hole 2 and receiv-
ing lens 3, using substances suitable
for camera lenses� Do not use sharp
objects or corrosive substances�
(see
Environmental protection
packaging should be sorted for envi-
ronment-friendly recycling�
The plastic components are labelled
for categorized recycling�
These instructions are printed on re-
cycled paper manufactured without
chlorine�
English
28
-
the
batteries
-
the
distance
Recycle
raw
instead of disposing as
waste.
Appliance, accessories and
are
to
be
materials
Publicidad
Tabla de contenido
