Safety And General Information; Installation And Removal - Save Phace I Serie Guia Del Propietario

NOTICE:
For your SAFETY - PLEASE read and follow all of these instructions exactly. If you have problems
understanding these instructions or have
questions, please call 1-866-783-3223.
Caution! Read and follow these instructions EXACTLY for care and cleaning of the lenses. These
lenses are made from the highest quality polycarbonate known to man WITH a Military Grade Anti
Scratch Coating AND the World's BEST Anti Fog Coating on the inside.
Remember, there is NO SUCH thing as a permanent Anti Fog coating. ALL anti fog coatings eventu-
ally come off. If you clean the lenses improperly, you'll increase the rate of deterioration or possibly
wipe off the coatings. So, PLEASE follow these instructions every time you clean the non-ADF lens.

SAFETY AND GENERAL INFORMATION

• Failure to comply with the enclosed may result in injury or blindness.
• WARNING: Risk of Ultraviolet Rays. Flying Particles. Wear Safety Goggles (User and
Bystanders).
• Materials which come into contact with the wearer's skin could possibly cause allergic reactions
to susceptible individuals.
• Scratched or damaged oculars (lenses) should be replaced.
• This is not a Paintball mask! It is a welding helmet.
• Toughened mineral filter oculars shall only be used in conjunction with a suitable backing ocular.
EFP MASK and LENS CARE INSTRUCTIONS (NON ADF)
1. NEVER use Windex®, 409® or any cleaner that has alcohol or ammonia in it to
clean your lens. Most lens cleaners have ammonia or alcohol that will deteriorate
the lens coatings and/or lens material and may cause the lens to weaken. If
your lens comes in contact with one of these, throw it away and order a new
replacement lens.
2. Clean your lens often.
3. Use warm clean water and a Micro fiber Lens Cloth Bag or lint free cotton cloth
to clean the lens.
4. Never store your lenses or mask near chemicals or fumes.
5. Never store your lenses or mask in hot places or near heat sources. i.e.; in the
trunk of your car, plastic bags, direct sun light. Always store in cool dry places.
6. Disinfect your EFP Helmet by rubbing a disinfectant cloth on all inside surfaces
of the EFP.
EFP LENS INSTALLATION and REPLACEMENT
• There are 4 Parts to the Lens Locking System; these are called Lens Anchors and
Lens Keys. Each piece is marked with an "R" and "L".
• If you do not install the Lens Anchors & Lens Keys correctly DO NOT Use the Mask.
• Press the lens firmly into the mask and install the Lens Locking Anchor that is
marked "R" installed on the Right side. Repeat on Left side.

INSTALLATION and REMOVAL

1. Insert the lens.
2. From the outside, install Lens Anchors, from the inside insert Lens Key through
the Lens Anchor until the Lens Key snaps into place. Reverse order of above to
remove.
WARNING
!
2