Save Phace I Serie Guia Del Propietario página 3

MASK FIT INSTRUCTIONS
9 Point High Quality Halo with 3 Adjustments Locations.
• For the top of the head adjustment; make the adjustment by aligning the strap to its
proper place depending on the size of your head.
• For the mask to fit tight PUSH IN and TURN the rear adjustment wheel on the
back of the head gear.
• FOR FORWARD AND AFT ADJUSTMENTS - Loosen the headgear outer locking
nuts and realign the headgear screws to the proper slots located INSIDE the EFP.
LENS CARE, INSTALLATION and REMOVAL INSTRUCTIONS
(ADF LENS)
To Clean: Remove ADF Filter from ADF Lens holder by removing the 4 screws off the
back ADF cover plate.
• Clean ADF Lens Holder with water only. Rinse ADF Lens holder under running
water, shake off residue and dry off with a Micro Fiber or lint free soft cloth.
INSTALLATION and REMOVAL of ADF, FRONT PROTECTIVE CLEAR
COVER LENS and REAR ADF PROTECTIVE COVER LENS
1. Remove the four finger screws and remove the REAR ADF Holder Plate to the Outer Lens.
2. Take out the old ADF Lens
3. When you replace the clear protective outer ADF Lens cover, squeeze the two tabs on the inside
and press outward. The clear protective lens will pop out of the Outer Lens. Gently snap in a new one.
4. Replace the old ADF Filter with a new ADF that matches the ADF Holder Lens
Shade as shown on the outside of the ADF Holder Lens.
5. Place the new ADF Filter with the Solar Panels facing the welding arc.
6. Place the rear ADF Holder over the ADF and install finger screws.
7. Do NOT over tighten finger screws.
INSTALLATION an/or REPLACEMENT OF ADF
COMPLETE ASSEMBLY
To remove the old ADF Complete Assembly:
1. Remove the 4 finger screws from the back of the ADF Complete Assembly.
2. Remove the back cover plate and spacer with gasket.
3. Remove rear clear protective ADF cover lens.
4. Remove ADF(for Gen Y models the Adjuster will need to be removed).
5. Uninstall the old ADF Complete Assembly by removing the lens keys and Lens
Anchors.
To install the New ADF Complete Assembly:
1. Install new ADF Holder Lens and install Lens Anchors and Lens Keys.
2. Install ADF into the ADF Holder Lens.
3. Install Spacer with gasket and rear clear protective ADF cover lens.
4. Install the back cover plate with 4 finger screws.
3