Personal Safety - Holmatro PRV 12 Manual De Instrucciones

NOTE
Emphasizes important information for optimal product use. This symbol is displayed in the
user manual with all regulations related to product use or maintenance.
Always adhere to these regulations and to the locally prevailing safety regulations, and proceed very
carefully.
Inform all people involved in the activities of the operation about these safety regulations.
2.2 Model plate and CE marking on the equipment
This part is used in a system and has therefore no marking.
2.3 General safety regulations
• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
• Prevent dirt in and on the couplers.
• Protect equipment against sparks during welding or grinding activities.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4

Personal safety

Personnel that uses or assists in the use of the equipment must wear all personal means of protection
as prescribed in the standard work procedure. Negligent use of personal means of protection can result
in serious injury. During use wear at least the following personal means of protection:
• Helmet;
• Safety goggles or full face shield;
• Safety gloves;
• Safety clothing for the entire body;
• Safety shoes with good ankle support and toe protection;
• Hearing protection during continuous use of pneumatic systems.
2.5 Safety regulations with respect to the equipment
• Never adjust the pressure regulation knob to a higher pressure than allowed for the tool(s)
connected to the pressure regulator.
• Do not pull on the hose or use the hose to carry the pressure regulator.
• The body of this regulator can get very cold.
• Do not drop the pressure regulator. Do not use the regulator when it dropped, internal damage
causes unsafe operation.
• Do not use the pressure regulator for a higher air pressure than specified.
PRV 12 (J) 916.001.485_000
EN
17