Thermador Masterpiece HMWB30WS Manual De Instrucciones página 20

Recirculating Kit (optional)
When used in recirculation mode, To Reduce the Risk of
Fire and Shock use only conversion kit Models
RECHMWB30 and RECHMWB36
Model
HMWB30WS
HMWB36WS
If it is not possible to vent cooking fumes and vapors to
the outside, the hood can be used in the non-vented
(recirculating) version, using the recirculating kit.
Fumes and vapors are recycled through the round grid.
Before installing the recirculation kit
The Installation of the Recirculation kit affects the installa
tion of the hood, so take into consideration the following
steps.
Cabinet or sofit preparation when
For cabinet or sofit preparation take into consideration that
Wall Mount Installation
First install delector on top of the hood then install to the
Fit four screws C on bottom of the delector, do not
C
C
.
Recirculating Kit
RECHMWB30
RECHMWB36
-
C
C
Install the delector on top of the hood so that screws C
Side Slots on bottom of Delector, slide Delector
Fit screws (dim:3.5x9.5), from inside the hood to inal
assembly Delector to the hood (number depends on
Charcoal ilter
In the reciruclating mode, the air will be recirculated
through disposable charcoal ilters that help remove smoke
• Remove the grease ilter of the hood.
•
charcoal ilter so that the slots on the ilter correspond
• Turn the carbon ilter clockwise to block them (bayonet
ixing).
NOTE: The charcoal ilters cannot be cleaned. It should be