Waste Ink Bottle Replacement; Waste Ink Bottle Replacement Procedure - Oki IP-5620 Guía De Consulta Rápida

Ocultar thumbs Ver también para IP-5620:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 102

Waste ink bottle replacement

This section explains the waste ink bottle replacement procedure. There are two situations that require
the waste ink bottle replacement procedure:
- When no waste ink bottle is installed
- When the waste ink bottle is full
The procedure for each case is described below.
Note
- Do not replace the waste ink bottle during printer operation.
- When replacing the bottle, use caution not to spill the ink. Use protective paper to prevent soiling.

Waste ink bottle replacement procedure

1
Remove the bottle from the waste ink spout
(tube) by slightly tilting the full waste ink
bottle.
2
Put the cap on the bottle and remove the
bottle.
3
Wipe off any ink stains around the waste ink
bottle.
4
Install a new (empty) waste ink bottle.
34
Waste ink spout
5
The following message is displayed to reset
(clear) the waste ink counter.
#BOTTLE EMPTY?
*NO
#BOTTLE EMPTY?
*YES
Note
- The printer automatically calculates waste ink with
a counter and displays the message prompting
replacement of the waste ink bottle when the
waste ink bottle is full. As there is no sensor for the
waste ink level, this calculation is just an estimate.
Therefore, if the waste ink counter is reset (set to
*YES) and the bottle is not empty, the waste ink
may overflow.)
6
Select "BOTTLE EMPTY? * YES" and press
key.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ip-5520

Tabla de contenido