Description Of Connection Points; Leds - Ingeteam INGECON SUN ComBox Manual De Instalacion Y Uso

Ingeteam

2.5. Description of connection points

Access to the INGECON SUN ComBox is found at the bottom of the unit as shown in the following figure.
1. Ethernet connector.
2. USB connector (B-type).
3. RS-485 input connector.
4. RS-485 output connector.
It is important to respect the permitted cable diameters suggested by the manufacturer of the packing glands:
230 Vac auxiliary power supply
Analogue inputs
Digital inputs

2.6. LEDs

The instructions for visually inspecting the device's operation are shown below.
9. Power supply LED.
10. Data transmission/reception LED.
11. Modem connection and coverage LEDs.
36
5 7 6 8
5 7 6 8
Access
1 2 3
5. 230 Vac power supply.
9 10 11 12 14
6. Analogue inputs (sensors).
7. Digital inputs (power setpoint).
8. Input for antennas.
1 2 3
Permitted cable diameter range
Packing gland
M12 x 1.5
M16 x 1.5
M12 x 1.5
9 10 11 12 14
12. Modem power supply LED.
13. Radiofrequency transmission/reception LED.
14. Radiofrequency power supply LED.
AAX2015IQM01_ - Installation and usage manual
Unit description
4
13
4
(mm)
3.5 ~ 7
4.5 ~ 10
3.5 ~ 7
13