INIM Electronics PREVIDIA MAX FPMCPU Manual De Instrucciones página 7

Installation manual
Connection of repeaters using power supplied by the control panel
Refer to Figure 3 - Repeater - a, page 20.
The jumper for the position on the BUS (paragraph 2 - [Q]) must be inserted in the EOL position EOL for the
control panel [A] and for the end-of-line repeater [B].
Connection of repeaters using power supplied by an external power-supply
Refer to Figure 4 - Repeater - b, page 20.
In this case the power to the repeaters [B] is not supplied by the control panel [A] but by an external power
supply [C].
EN54:
The power-supply unit employed must be EN54 standard compliant.
Directive 2014/53/EU
compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. This product may be used in
all EU Countries.
Documents for the users
concerning to INIM Electronics S.r.l. products may be downloaded free of charge from the web address www.inim.biz, getting
access to Extended Access and then selecting "Certifications" or requested to the e-mail address info@inim.biz or requested by
ordinary mail to the address shown in this manual.
Manuals may be downloaded free of charge from the web address www.inim.biz, getting access to Extended Access and then
selecting "Manuals".
WEEE
Informative notice regarding the disposal of electrical and electronic equipment (applicable in countries
with differentiated waste collection systems)
The crossed-out bin symbol on the equipment or on its packaging indicates that the product must be disposed
of correctly at the end of its working life and should never be disposed of together with general household waste.
The user, therefore, must take the equipment that has reached the end of its working life to the appropriate civic
amenities site designated to the differentiated collection of electrical and electronic waste.
As an alternative to the autonomous-management of electrical and electronic waste, you can hand over the
equipment you wish to dispose of to a dealer when purchasing new equipment of the same type. You are also
entitled to convey for disposal small electronic-waste products with dimensions of less than 25cm to the
premises of electronic retail outlets with sales areas of at least 400m2, free of charge and without any obligation
to buy.
Appropriate differentiated waste collection for the subsequent recycling of the discarded equipment, its treatment and its
environmentally compatible disposal helps to avoid possible negative effects on the environment and on health and favours the
re-use and/or recycling of the materials it is made of.
Information about disposal of batteries and accumulators (applicable in Countries with separate collection
systems)
This marking on batteries and/or their manual and/or their packaging, indicates that batteries of this products, at
the end of their working life, should not be disposed of as unsorted municipal waste, but must be object of a
separate collection. Where marked, the chemical symbols Hg, Cd o Pb indicate that the battery contains
mercury, cadmium or lead above the reference levels of the directive 2006/66/EC. If batteries are not properly
disposed of, these substances, together with other ones contained, can cause harm to human health and to the
environment.
To protect human health and the environment, to facilitate treatment and recycling of materials, separate batteries from other
kind of waste and use the collection scheme stated in your area, in accordance to current laws.
This product contains a lithium metal button cell type CR2032. Furthermore, for proper operation and compliance with
product standards, the installer must install a couple of lead-acid accumulators for backup use type NPL24-12I or NP 17 -12-FR
or equivalent (not supplied).
Before disposing of the above, it's appropriate to remove them from their holders avoiding to damage them or causing short
circuits.
Copyright
The information contained in this document is the sole property of INIM Electronics s.r.l. No part may be
copied without written authorization from INIM Electronics s.r.l. All rights reserved.
Module wiring - repeater connection
Hereby, INIM Electronics S.r.l. declares that these Previdia Max control panels are in
Declarations of Performance, Declarations of Conformity and Certificates
7