General Description - INIM Electronics PREVIDIA MAX FPMCPU Manual De Instrucciones

Installation manual
1 About this manual
Manual code: DCMIIN1PFPMCPU
Version: 1.30
2

General Description

The FPMCPU module is the main unit of the control panel and contains the main CPU with all the system
configuration data.
Each module in the Previdia Max system has its own independent CPU. Each FPMCPU unit contains two CPUs:
a main CPU and a emergency backup CPU. The backup CPU will take over in the event of fault on the main
CPU.
The emergency backup CPU ensures the efficiency of the basic functions of the system (alarm signal reception
from points and activation of outputs). However, it does not ensure all the configured activation logic. For total
redundancy of all the configured functions, it is necessary to add and configure a second FPMCPU unit to the
control panel.
The FPMCPU front-plate module has three operating modes:
• main unit of the control panel
• backup unit
• remote repeater user-interface
FPMCPU comes with:
• CAN BUS cable
• 6 screws with washers for securing the module
• 2 system access keys
• 2 ferrites
• Instructions manual
l
[A]
Touchscreen display
[B]
Status LED
[C]
LED and function button
[D]
LED and multiple-alarm button
[E]
Access-key slot
[F]
Speaker
[G]
Ground connection wire
[H]
Mounting screw locations
About this manual
Figure 1 - FPMCPU, page 1
CR2032 battery (included,
[I]
for internal clock)
[J]
MicroSD card holder
Button to reset default
[K]
settings (factory settings)
[L]
Reset button
[M]
Ethernet port
[N]
CAN bar connector
Connector for other front-
[O]
plate module
RS485 terminal board for
[P]
repeaters
[Q]
EOL jumper connectors
RS485 MODBUS terminal
[R]
board
MODBUS EOL jumper
[S]
connectors
[T]
For future use
[U]
USB mini port
[V]
Serial connector
programming jumper
[W]
connectors
5