Tabla de contenido
Publicidad
EN
IMPORTANT
Please read these instructions carefully before you start to assemble this greenhouse.
Keep these instructions in a safe place for future reference.
» Customer Service
For assistance with assembly or for replacement parts – please log onto our website
or call our service line (number is on the title page).
Additional information can be found at our website: www.palramapplications.com
» Safety Advice
•
It is of utmost importance to assemble all of the parts according to the directions.
Do not skip any step.
•
We strongly recommend using work gloves during assembly.
•
Always wear shoes and safety goggles when working with extruded aluminium.
•
If using a step ladder or power tools ensure that you follow the manufacturer's safety advice.
•
Do not touch overhead power cables with the aluminium profiles.
•
Do not attempt to assemble the greenhouse in windy or wet conditions.
•
Dispose of all plastic bags. Keep them out of reach of small children.
•
Keep children away from the assembly area.
•
Do not lean against or push the greenhouse during construction.
•
Do not position your greenhouse in an area exposed to excessive wind.
•
Do not attempt to assemble this greenhouse if you are tired, have taken drugs or
alcohol or if you are prone to dizzy spells.
•
Hot items such as recently used grills, blowtorches etc. must not be stored in the
greenhouse. Ensure there are no hidden pipes or cables in the ground before
inserting the pegs.
•
This product is designed to be used mainly as a greenhouse.
•
Note: You should anchor the greenhouse directly to a solid foundation; Make sure
that there are no obstructions between the assembly area and the final position.
» Care & Maintenance
•
When your greenhouse needs to be cleaned, use a mild detergent solution and rinse
with cold clean water.
•
DO NOT use acetone, abrasive cleaners or other special detergents to clean the clear panels.
» Tools & Equipment
•
•
Scissors
Work gloves
•
•
Electric screwdriver ( 10mm, 7mm, Phillips)
Phillips head screwdriver
•
•
Adjustable Spanner / Wrench
Lubricant (Optional)
•
•
Leveler
T001 - Special tool for Screws 411 and nuts 412
•
Tape measure
•
Step ladder
» Before Assembly
Selecting a site:
- The greenhouse must be positioned and fixed on a flat level surface.
- Choose a sunny position away from overhanging trees.
We strongly recommend this greenhouse to be secured directly to a solid concrete
foundation.
This is a multi-part assembly best achieved by two people. Allow at least
half a day for the assembly process.
Take all components & parts out of the packages. Sort the parts and check against the
content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do
not get lost.
Please note multi-sided profiles are used in this greenhouse. As a result some holes in the
profiles are not used during assembly.
Please review entire instructions before starting. Carry out the assembly steps in exact order.
The drawings in this manual are designed for 8' x 8' greenhouse + 4' Extension Kit. Please
note that content list refers only for 8x8 greenhouse.
Note: all the extension module steps are marked with a dashed outline, should be
performed during the greenhouse assembly process.
4 mm
5/32"
Publicidad
Tabla de contenido
