NOTE:
Closing the detector bracket may be a little difficult. While closing the bracket the
test button may possibly be pressed.
Replacing the Battery
1. Remove the plastic mounting bracket from the detector (see Figure 5).
2. Remove the old battery.
3. Insert the new battery while observing battery polarity (see Figure 11).
4. Close the battery compartment cover.
Configuration
Configuring the detector
To ensure the detector can detect the system receiver, register the detector by
entering the 11-digit serial code or perform the following steps for assigning the RF:
1. Set the system receiver to "Learn" mode.
2. If not already performed, connect the battery.
3. Send an allocation message by pressing the tamper button for at least 3
seconds (or connect the detector to the mounting bracket) until the system
receiver indicates that it has received the allocation message.
Upon successful registration, the detector's green LED indicator makes 4 short blinks.
Figure 9
Figure 11
8
LED Indicator
Figure 10