Corsair VENGEANCE 2100 Guia De Inicio Rapido página 4

1
Connect the wireless USB adapter to any
working USB port on your PC or connect the
USB extension cable to your PC, and then attach
the wireless adapter to the extension cable.
Using the USB extension cable may extend
the wireless range of your Vengeance 2100, by
allowing you to position the antenna to get the
best reception. Using the USB extension cable can
make it easier to move the adapter from PC to PC.
The Vengeance 2100 is designed to operate
at a range of up to 40 feet (12m) from the
wireless adapter, but other wireless devices,
electronics, and obstructions such as walls may
reduce wireless range.
IMPORTANT: The first time you use the
Vengeance 2100 wireless adapter on a PC, the
Operating System will automatically install the
device driver. After the device driver loads we
recommend you reboot your PC before you use
your headset.
2
IMPORTANT:
The Vengeance 2100 wireless headset
must be fully charged before its first use.
• Connect the USB charging cable to
any working USB port on your PC
• If desired, turn o the headset by
pressing the power button for
approximately 1–2 seconds.
• Connect the USB charging cable to the
Vengeance 2100.
When the USB charging cable is plugged in, the
battery life indicator on the Vengeance 2100 lets
you know the charge status:
U No light
The headset is o , or the
battery is fully drained
Red — fast blinking
˜
Low battery (less than
10% charge remaining)
Amber — slow pulse
˜
Charging
˜ Green — solid
Charge complete
The first time you charge the Vengeance 2100,
it may take up to 4 hours. Do not use the
headset until the battery life indicator is green.
The advanced Lithium Ion battery will power
the Vengeance 2100 for up to 10 hours of
typical use.
If you hear the low battery tone (1kHz beep
@ -12dB every 60 seconds) or the battery life
indicator blinks red, this means you are running
low on battery life. If this happens, connect
the USB charging cable to the Vengeance 2100
so it can continue to be used and charged.