Descargar Imprimir esta página

General Description Of 'Ivac Pro System - IVAC Pro Guía Del Usario

Publicidad

Idiomas disponibles

Idiomas disponibles

General Description of 'iVAC Pro System'

3
The 'iVAC Pro System' consists of a combination of the
following module types, to enable the automation of the end
users workshop. The modules are, the 'iVAC Pro Tool', 'iVAC
Pro Switch', iVAC Pro Remote, iVAC Contactors and a series
of automatic blast gates.
The 'iVAC Pro Tool' unit interfaces a Power Tool to the 'iVAC
Pro System'. Initially there were three variants of the 'iVAC Pro
Tool' unit; T11515NA, T11520NA and T24020NA. These three
units are planned to be phased out by Q1, 2015 and replaced
with a single unit, the 'iVAC Pro Tool Plus'.
The following description will refer only to the 'iVAC Pro Tool
Plus' version. (Tool Plus.)
An iVAC Pro System may consist of up to eight power tools
with their associated 'Tool Plus' units and at least one 'iVAC
Pro Switch' unit. By means of the System Address up to four
iVAC Pro Systems can operate in the same workshop.(Sec
4.2)
If a 'Tool Plus' unit is in the Auto mode when its related power
tool is powered on, the 'Tool Plus' unit will transmit a

Publicidad

Capítulos

loading