Style selections VANITY COMBO Guía De Uso Y Cuidado página 6

INSTALLATION
4. Remove vanity top from vanity base. Apply a thin bead of silicone compound around the vanity base and set the
vanity top carefully in place. Remove any excess silicone compound with a wet rag.
5. Install water lines and P-trap according to manufacturer's installation instructions.
4
Drawer Installation
Full extension drawer glide installation (If applicable)
1. close completely both slides attached to the vanity.
2. move the component of the slides with ball bearings to the front of the slides, maintaining the slides completely closed.
3. carefully line up the slides of the drawer box with the slides in the base cabinet and close the drawer all the way to the back.
4. open the drawer completely to ensure it is properly installed.
Epoxy drawer glide installation (If applicable)
1. in a 30 ° angle position, introduce the drawer in the base cabinet making sure the drawer slide wheels are above the vanity slide wheels.
2. close the drawer completely to ensure it has been properly installed, open it as far as possible.
5
Hinge/door Adjustment (If applicable)
The door alignment was set in the factory, but it could have shifted during transit. If adjustment is needed, follow the instructions provided in chart
*
below.
A Used to adjust door height B Used to adjust gaps between
doors
�
CABINET FRONT VIEW CABINET FRONT VIEW
6
Mirror Installation (If Included)
NOTE: Some mirrors have hanging brackets that allow for vertical or horizontal installation.
NOTE: Be sure the hanging hardware is rated to handle the weight of the mirror. The mirror weight is
approximately 20 lbs.
1. Determine the desired location of the mirror.
2. Use appropriate screws or wall anchors (not included) to hang mirror.
6
C Used to adjust between
door and cabinet
\ 6 �
�
�
CABINET SIDE VIEW