Safety Overload - Apex Mini Neb Manual De Instrucciones

Mini Neb /English
9. When the treatment is complete, turn off the compressor by pressing the power switch to
O (OFF) position and unplug the unit from the electrical outlet.
Equipment not suitable for use in the presence of a flammable anesthetic mixture
with air or with oxygen or nitrous oxide. This device has no AP or APG protection.

3.2 Safety Overload

NOTE - Do not exceed 30 minutes of continuous operation.
1. The motor of this device has a built-in thermal overload protector. Should the motor
overheat, the protector will automatically shut off the motor. Should this occur, turn the
I/O (ON/OFF) switch to the O (OFF) position and allow the motor to cool down for
approximately 30 minutes before turn it on again.
2. If the overload protector shuts off the motor frequently, you may have an unstable voltage
situation.
3. If the unit shuts down and cannot restart, it may need to be replaced. Call your provider
immediately.
4. Cleaning
4.1 Compressor Outer Case Cleaning
WARNING -
Electric shock hazard. Do not remove outer case of this unit. All disassembly and
maintenance of this unit must be done by a qualified service technician. Refer servicing to
qualified service personnel.
WARNING -
This unit does not require oil. Do not attempt to lubricate any internal parts.
WARNING -
Unplug unit before cleaning. Do not submerge in water for cleaning.
1. Wipe the main unit with a damp cloth every few days to keep it dust-free.
2. Do not use any powdered type cleaners or soap. Do not submerge the unit into water.
4.2 Nebulizer Cup Cleaning
All parts of the disposable nebulizer, except tubing, should be thoroughly cleaned after each
use. If your doctor specifies a specific cleaning procedure, follow that procedure.
WARNING - To prevent possible risk of infection from contaminated medication, cleaning of the
nebulizer is recommended after each treatment.
7