Apex Mini Neb Manual De Instrucciones página 9

Mini Neb /English
3. Operation
NOTE -
Before initial operation, the nebulizer cup assembly should be cleaned following
instructions described in the "Cleaning" section.
WARNING -
Before connecting the power cord, make sure the I/O (ON/OFF) switch is in the O
(OFF) position.
The plug is also served to disconnect the device. Do not position the equipment so that
it is difficult to disconnect the device.
3.1 Daily Use Operation
CAUTION -
The MiniNeb Compressor is designed for intermittent use only. Do not operate it
continuously for more than 30 minutes for a single use without turning it off and following a
cooling period for least 30 minutes.
1. Before each use inspect the MiniNeb Compressor and nebulizer cup assembly for damage
or wear, replace as needed.
2. Place the MiniNeb Compressor on a table or other flat stable surface. Be sure you can
easily reach the controls when seated. Do not use this device on the floor.
3. With the power switch in the O (OFF) position, plug the power cord into an appropriate
electrical wall outlet.
4. Connect one end of the tubing to the compressor air-outlet connector.
5. Assemble the nebulizer cup and add indicated medication to the nebulizer's cup before
use.
6. Attach the other end of the tubing into the air-inlet connector founded at the bottom of
the nebulizer cup.
7. Turn on the MiniNeb Compressor by pressing the power switch to the I (ON) position and
begin treatment.
8. If treatment needs to be interrupted, simply press power switch to O (OFF) position.
6