WattStation™ Wall Mount User Manual
2.3
Hardwired Version
2.3.1 Before Installation
WattStation should be installed only by a licensed contractor, and/or a licensed electrician in
accordance with all applicable state, local and national electrical codes and standards.
WARNING: Danger of electrical shock or injury. Turn OFF power at the panelboard or load center before
working inside the equipment or removing any component. Do not remove circuit protective devices or
any other component until the power is turned OFF.
Ensure that a dedicated circuit, capable of supplying 30A at 208-240 VAC, is available
•
Power feed must have a centrally grounded neutral in order for WattStation to function correctly.
•
A recommended 40A upstream circuit breaker, located either in a panelboard or load center,
•
should be used
Power and ground wires for WattStation go in through the back of the unit as a default.
•
Optionally, the power may be fed through the bottom or top of the unit. Plan ahead on how you
will supply power to WattStation
Recommended mounting hardware for wood studs are 1/4" x 2" hex head lag bolts
•
Recommended mounting hardware for concrete walls are 1/4" x 1-3/4" concrete hex screws or
•
1/4" x 1-7/8" concrete anchors
2.3.2 Installation
Step 1: Carefully unwrap the packaging and make sure the following items are present:
Step 2: Check for any damage to the unit, the cord or the connector. If no damage is noticed, proceed to
step 3. If damage is noticed, call 1-888-GE-RESOLve.
-Wall Mounted WattStation unit
-Mounting wall bracket
-Key for WattStation mounting lock
Step 3: Install wall mount bracket to the wall. Use the mounting wall bracket as a template for the wall-
mounting holes. The distance from the floor to bottom of the wall mount bracket should be 18" minimum
for indoor use and 24" minimum for outdoor use. The distance to the top of the unit should be 48"
maximum for all applications per NEC 625.29. For ADA compliant installation, refer to ADA accessibility
guidelines, section 4.2. Make sure the bracket is aligned so that power wire will fit through the WattStation
enclosure holes (for back-entry wiring only).
7
GE Energy
©2012 GE Company All Rights Reserved