WattStation™ Wall Mount User Manual
Step 6: Feed the supply power and ground wires through WattStation enclosure holes. Slide WattStation
onto the mounting bracket, ensuring that the opening in the back plate bracket aligns with the tab on the
wall mount bracket.
Step 7: Connect supply power wires to line side of fuse block and ground wire to the ground bar.
Step 8: Replace the deadfront shield and reconnect the wires going to the front cover components and
replace the oval snap-fit ring.
3. User Manual
3.1 Basic Features
Charging cord and connector provide link to electric vehicle
•
LED ring provides illumination around connector
•
Green indicator light displays when WattStation is in charge mode
•
Red indicator light displays when WattStation is in fault mode
•
On/Off button allows total power shutdown
•
Tamper-proof / theft-proof key lock secures WattStation to the wall bracket
•
Padlock option on connector provides additional physical security
•
Availability of plug-in or hardwired version provides installation flexibility
•
Entry options for supply power cable include top, bottom and rear and provide additional
•
flexibility for the hardwired version
3.2 Turning WattStation On and Off
WattStation can be turned on by pressing in the On/Off pushbutton. When on, the LED ring around the
connector will glow white.
WattStation can be turned off at any time by pressing the On/Off button again. The LED ring will turn off.
3.3 Connecting and Disconnecting to Vehicle
Connect to Vehicle When the connector is seated in the WattStation holder, press and hold the button on
the connector handle and pull away from the holder until it is fully removed.
Press and hold the button on the connector handle and insert into the vehicle's inlet socket. Release the
button on the connector handle when fully connected to the vehicle inlet socket.
Once the WattStation handle is connected to the vehicle, the charge status indicator will illuminate green.
9
GE Energy
©2012 GE Company All Rights Reserved