Measurement Point Illumination; Maintenance; Battery Replacement - koban KCL-01 Manual De Instrucciones

KCL-01

4. Measurement Point Illumination

Press button flashlight button for measurement point illumination. The instrument
switches off automatically after approximately 60 seconds or it can be switched off
manually when pressing the flashlight button again.

5. Maintenance

When using the instrument in compliance with the Users Manual, no special maintenance
is required. For any queries regarding the instrument, please always quote product
designation and serial number, both marked on the type shield label on instrument rear. If
functional errors occur after expiration of warranty, our after sales service will repair your
instrument without delay.

6. Battery Replacement

Receiver batteries have to be changed, when the symbols are vacant"
Transmitter batteries have to be changed, when the symbols are displayed.
• Disconnect the instrument from the mains and switch them off.
• Open and remove battery case cover on instrument rear.
• Remove used batteries
• Insert new batteries by respecting the polarity
• Close battery case
• The instrument is now operational.
Note:
Prior to storage battery replacement, disconnect the instrument from any connected
test leads.
Reverse polarity of batteries may destroy the instrument. Furthermore, they may
explode or ignite
Only use batteries as described in the technical data section!
(One 9V battery , NEDA 1604, IE6F22.Power).
Never try to make contact between both battery cell poles, for example by using a
wire connection. The resulting short-circuit current is very high and causes extreme
heat. Danger of fire and explosion !
23
EN EN
Please consider your environment when you dispose of your one-way batteries or
accumulators. They belong in a trash for hazardous waste. In most cases, the
batteries can be returned to their point of sale. Please, comply with the respective
valid regulation regarding the return, recycling and disposal of used batteries and
accumulators.
If an instrument is not used over an extended time period, the batteries must be
removed. Should the instrument be contaminated by leaking battery cells, the
instrument has to be returned for cleaning and inspection to the factory.
"displayed.
KCL-01
24