Adjusting The Solution Water Flow; Drying With The Brush Raised - Kruger KFL450E Manual Del Usaurio

Photo 32
7.11 ADJUSTING THE SOLUTION WATER
FLOW
The flow of the solution water can be adjusted
operating the tap located on the right of the control
panel.
Set the solution flow control lever in an interme-
diate position between the closed ( Photo 33 - A )
and fully opened ( Photo 33 - B ) position, accor-
ding to the kind of cleaning to be performed.
The machine is provided with a solenoid valve; the so-
lution water outlet occurs only when the machine is
working, by pulling the control lever ( Photo 2 - A );
to allow the water solution outlet it is necessary to
set the brush motor switch to the "ON" position. (
Foto 5 - C ; Foto 7 - C ).
Photo 33
Solution water outlet tap
A: Tap closed
B: Tap opened
7 - OPERATING INFORMATIONS
A
B

7.12 DRYING WITH THE BRUSH RAISED.

The special squeegee support (Photo 34) allows to
lift the machine - by turning it to the rear wheels -
leaving the squeegee on the floor.
It is thus possible to dry the floor with the brush
raised off the ground (Photo 35).
45
Photo 34
Photo 35