Important Safety Information - Samson SM10 Manual Del Usuario

Important Safety Information

1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
This apparatus shall not be exposed
to dripping or splashing liquid and no
object filled with liquid, such as a vase,
should be placed on the apparatus.
6.
Clean only with a dry cloth.
7.
Do not block any of the ventilation
openings. Install in accordance with
the manufacturer's instructions.
8.
Do not install near any heat sources
such as radiators, heat registers,
stoves, or other apparatuses (including
amplifiers) that produce heat.
9.
Only use attachments/accessories
specified by the manufacturer.
10.
Unplug this apparatus during lightning
storms or when not in use for long
periods of time.
11.
Do not override the intended purpose
of the polarized or grounding-type plug.
A polarized plug has two blades, with
one wider than the other. A grounding-
type plug has two blades and a third
grounding prong. The wide blade, or
third prong, is provided for your safety.
If the provided plug does not fit your
outlet, consult an electrician to replace
the obsolete outlet.
12.
Protect the power cord from being
walked on or pinched, particularly at
the prongs, convenience receptacles,
the point where they exit from the
apparatus.
13.
Use only with the cart stand, tripod
bracket, or table specified by the
manufacture, or sold with the
apparatus. When a cart is
used, utilize caution when
moving the cart/apparatus
combination to avoid
injury from tip-over.
4
14.
Refer all servicing to qualified service
personnel. Servicing is required if the
apparatus has been damaged in any
way, such as power-supply cord or
plug breakage, damage due to liquid
or objects falling onto the apparatus,
exposure to rain or moisture, or if the
apparatus does not operate normally, or
has been dropped.
15.
POWER ON/OFF SWITCH: For products
with a power switch, the power switch
DOES NOT break the connection from
the mains.
16.
MAINS DISCONNECT: The plug should
remain readily operable. For rack-
mount or installation where plug is not
accessible, an all-pole mains switch
with a contact separation of at least
3mm in each pole shall be incorporated
into the electrical installation of the
rack or building.
17.
FOR UNITS EQUIPPED WITH
EXTERNALLY ACCESSIBLE FUSE
RECEPTACLE: Replace fuse with same
type and rating only.
18.
MULTIPLE-INPUT VOLTAGE: This
equipment may require the use of a
different line cord, attachment plug, or
both, depending on the available power
source at installation. Connect this
equipment only to the power source
indicated on the equipment rear panel.
To reduce the risk of fire or electric
shock, refer servicing to qualified
service personnel or equivalent.