Installation And Use - Guardian Fall Protection SRL Serie Manual De Instrucciones

Installation and Use

Guardian Fall Protection Edge Series SRL part # 10909
MUST NEVER be used in Leading Edge (LE) applications.
All other Edge Series SRL part #s may be used in LE applications if used in combination
with shock absorber extension deemed compatible with SRL by a Competent Person.
If intending to use Edge Series SRL in LE applications,
refer to additional LE SRL use instructions (pg. 12).
ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.
1. All components of the personal fall arrest system must be selected and deemed compatible
with applicable SRL by a Competent Person.
2. Ensure structure to which SRL is to be attached, and on which work is to be performed, is free
of all hazards, including, but not limited to, debris, rot, rust, sharp or abrasive edges and
surfaces, and hazardous materials.
3. Edge Series SRLs may be used in either mobile or stationary applications. In non-LE
applications, SRL must always be positioned at or above harness dorsal D-ring AND at or
below anchor point. In LE applications, anchorage connection point may be at most 2'
below harness dorsal D-ring.
4. For stationary applications, attach Edge Series SRL carabiner to selected anchorage connector,
and attach snap hook to applicable harness D-ring.
5. For mobile applications, attach SRL carabiner to harness Dorsal D-ring, and attach snap hook
to selected anchorage connector.
6. Ensure 100% tie-off will be maintained at all times, which may require the use of a back-up
or supplementary fall protection system.
11