Installation And Use; Maintenance, Cleaning, And Storage - Guardian Fall Protection Diablo 2.0 SRL Manual De Instrucciones

Installation and Use

Guardian Fall Protection Diablo SRLs MUST NEVER be used in Leading Edge (LE) applications.
Maximum permitted free fall is 2'.
ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.
For Double-Leg Kits (Part #s: 11084CSA, 11085CSA, 11086CSA, 11087CSA, assemble and use SRL
according to instruction sheet provided with Dual SRL Bracket (part # 11058).
1. All components of the personal fall arrest system must be selected and deemed compatible with Diablo SRL
by a Competent Person.
2. Ensure structure to which Diablo SRL is to be attached, and on which work is to be performed, is free of all
hazards, including, but not limited to, debris, rot, rust, sharp or abrasive edges and surfaces, and hazardous
materials.
3. Diablo SRLs may be used in either mobile or stationary applications. SRL may be positioned no more than
2' below harness dorsal D-ring or 2' above anchor point.
*If using Diablo with rebar hook configuration, Diablo must always be worn at harness dorsal D-ring. Rebar
hook must ONLY be connected to structural rebar, or other structural anchor (such as angle iron or concrete
form) deemed compatible with Diablo SRL by Competent Person.
4. For stationary applications, attach Diablo SRL to selected anchorage connector, and attach snap hook to
applicable harness D-ring.
5. For mobile applications, attach Diablo SRL at harness Dorsal D-ring, and attach snap hook to selected
anchorage connector.
6. If using double leg Diablo SRL, ensure 100% tie-off will be maintained at all times; ALWAYS attach
disengaged snap hook or rebar hook to a compatible anchorage connector prior to unhooking engaged snap
hook or rebar hook.

Maintenance, Cleaning, and Storage

If Diablo SRL fails inspection in any way, immediately remove it from service, and contact Guardian to inquire
about its return or repair.
Cleaning after use is important for maintaining the safety and longevity of Diablo SRL. Remove all dirt,
corrosives, and contaminants from Diablo SRL before and after each use. If Diablo SRL cannot be cleaned
with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean Diablo SRL with corrosive
substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals,
or other degrading elements.
4