Installing Your Wall Entry Aluminum Pet Door Measure; Tape; Cut Interior Wall - Petsafe PPA11-10915 Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing Your Wall Entry Aluminum Pet Door
Step 1
Measure
1A. Locate the site for the Wall Entry Aluminum Pet
Door
. Locate the studs in the proposed area. Locate
the center between the two studs. Using a pencil,
draw a 5" (12.7 cm) vertical line on center about 10"
to 12" (25.4 cm to 30.5 cm) above the floor.
1B. Mark the shoulder height of your pet on the vertical
line. Draw a horizontal line through your mark.
Step 2

Tape

2A. Place the template against the wall. Align the lines on the
template with the lines on the wall. Tape in place.
2B. Check that the template is square.
2C. Carefully trace the template with a pencil. Remove the
template from the wall. Take a moment to review the hole
location to ensure that the template is level and that this is
the best possible location for the pet door.
Step 3

Cut Interior Wall

3A. Drill out the four corners of the rectangular hole with
a
" (8 mm) drill bit.
5
16
Helpful Tip: Use both hands to hold drill steady and
straight at a 90° angle.
3B. Carefully cut the hole out using a jigsaw or other
appropriate cutting device. Cut on line.
Helpful Tip: When cutting use both hands to hold
the saw slow, steady and straight at a 90° angle.
Check for electrical and plumbing fixtures that could be in the wall where
you wish to place the pet door.
www.petsafe.net
1A
Center Between
Studs
1B
10"-12"
2A
3A
Shoulder Height
2B
2C
3B
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ppa11-10916Ppa11-10917Hpa11-10918Hpa11-10919Hpa11-10920

Tabla de contenido