The following parts are required to fit the guard
and line cutter
4 x locking bolts
4 x locking nuts
4 x washers
1 x 4mm Allen key
1 x spanner
•
Loosen the metal mounting bracket using
the 4mm Allen key and spanner
•
Once loosened, pull the metal bracket away
from the plastic mounting on the pole.
•
Place the blade guard up to the mounting
bracket.
•
Make sure that the holes on the mounting
bracket and blade guard line-up.
•
Insert the locking bolts through the plastic
retaining bracket on the main pole.
8