Main Menu; Settings - FAAC TM2 X TT-50 Manual De Instrucciones

This screen allows to have access to various functions of the remote control:
1) COMMANDS – this is the section which you will use daily. You will be able to select a
device, a group or a scenario among the previously saved ones and activate the motors
related to the selection using the UP, DOWN and STOP keys. In the installation phase
it is possible to program the maximum opening and closing positions and the middle
position.
2) PROGRAMMING – This sections will allow you to create or modify devices, groups,
scenarios, days and weeks. You will also be able to set the operation mode (manual,
automatic/daily, automatic/weekly). In order to avoid involuntary changes of the
programming during daily use, it is possible to set a "Program lock" (see SETTINGS)
3) SETTINGS – This section will allow you to change the language, the day of the week
and the time, the brightness of the display and the display switching-off time starting
from the last key pressing. It is also possible to modify some parameters concerning the
radio-transmission of commands.
This section will allow you to change both the basic setups of the remote control (language,
day, time) and the values which have been pre-set in the factory.
ATTENTION! When you replace fl at batteries, all settings and the programming carried
out until the time of replacement will be held in the remote control memory. The only
exception will be the "time and day", which will have to be set when the remote
control is started.
LANGUAGE, DAY AND TIME SETTING
Language setting:
Main menu / Settings / Language
Move to the required language using the UP/DOWN keys, press SELECT + SAVE.
Day & Time setting:
Main menu / Settings / Day & Time
Set the required values*, then press SAVE.
TM2 X TT-50

MAIN MENU

SETTINGS

25 A4518_6H04_Rev.A