Operating Instructions; Technical Characteristics - Tractel PB05 0-100 Modo De Empleo

Ocultar thumbs

Contenido

página de 30

/ 30
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Positioning: suspend the grab, in a stable position, in its open position by its ring (1) (locking pawl (2)

activated).

To perform lifting, present the grab vertically to the product to be lifted.

Lower the grab until it is applied against the load. Check that the clamp stays in a vertical position

Swivel the locking pawl (2) manually whilst starting off the lifting.

Release the locking pawl (2) making sure its claw is well above the fastening screw (3) and perform

lifting. Check at all times the loads' stability and good adherence before going on to the next step.

Lay down the load immediately if it starts to slide or turn.

Lift the load in a regular way and use the handles (4) to guide the grab. When turning the load (ZAC

model), be sure that there is enough space between the load and eventual obstacles

When laying the load down, bring down the grab until the locking pawl automatically locks (2) onto

the fastening screw (3).

The grab is locked in the open position. It can be lifted up and it is ready to be used again.

The technical sheets T 6010 (PB) and T 6009 (ZAC) are at your disposal for technical characteristics and more

Reference

ZAC 60-250

ZAC 250-390

ZAC 390-650

ZAC 600-1000 51318

ZAC 700-1250 51328

PB05 0-100

PB05 100-250 50468

PB05 200-500 50478

PB1 0-200

PB1 200-500

PB1 500-800

PB1 700-1000 50518

PB3 200-500

PB3 500-800

M 6110 M

rev 6 – 11/02/2014