ASROCK ALiveXFire-eSATA2 Manual De Instrucciones página 18

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Radeon
TM
CrossFire
Edition graphics
card
Connect the DVI-DMS
cable to DMS connector
of the CrossFire
graphics card.
If you install two CrossFire
connect one end of DVI-DMS cable to the monitor, another end to DMS of one
of the CrossFire
DVI of another CrossFire
If you install one CrossFire
dard Radeon (CrossFire
connect one end of DVI-DMS cable to the monitor, another end to DMS of the
CrossFire
standard Radeon (CrossFire
Step 6.
Power on your computer and boot into OS.
Step 7.
Remove the ATI
The Catalyst Uninstaller is an optional download. We recommend using this
utility to uninstall any previously installed Catalyst drivers prior to installation.
Please visit this website for the driver:
http://support.ati.com/ics/support/DLRedirect.asp?
fileIDExt=050553d40196ef109fff37cbb40aaf28&accountID=737&deptID=894
Step 8.
Install the required drivers to your system. Please visit the websites below
for installing the drivers that ATI
TM
A. ATI
recommends Windows
installed (If you have Windows
in your system, there is no need to download it again):
http://www.microsoft.com/windowsxp/sp2/default.mspx
B. You must have Microsoft .NET Framework installed prior to
downloading and installing the CATALYST Control Center:
http://www.microsoft.com/downloads/details.aspx?
FamilyId=262D25E3-F589-4842-8157-034D1E7CF3A3&displaylang=en
Step 9.
Restart your computer.
1 8
1 8
1 8
1 8
1 8
ASRock ALiveXFire-eSATA2 Motherboard
DMS
connector
TM
Edition
TM
Edition graphics cards to this motherboard, please
TM
Edition graphics cards to PCIE3 slot, and the other end to
TM
Edition graphics card to PCIE2/PCIE SWITCH slot.
TM
Edition graphics card and one compatible stan-
TM
Ready) graphics card to this motherboard, please
TM
Edition graphics card, and the other end to DVI of the compatible
TM
Ready) graphics card.
TM
driver if you have any VGA driver installed in your system.
TM
recommends:
®
XP Service Pack 2 or higher to be
®
XP Service Pack 2 or higher installed
Connect the DVI-DMS
cable to the monitor
connector.

Publicidad

Tabla de contenido
loading

Tabla de contenido