Atx 12V Connector (Atx12V1); Cpu Fan Connector (Cpu_Fan1); Chassis Fan Connector (Cha_Fan1) - ASROCK ALiveXFire-eSATA2 Manual De Instrucciones

System Panel Header
(9-pin PANEL1)
(see p.2 No. 23)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.2 No. 24)
Chassis Fan Connector
(3-pin CHA_FAN1)
(see p.2 No. 22)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.2 No. 3)
Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin
CPU fan still can work successfully even without the fan speed control function.
If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this
motherboard, please connect it to Pin 1-3.
ATX Power Connector
(20-pin ATXPWR1)
(see p.2 No. 4)
ATX 12V Power Connector
(4-pin ATX12V1)
(see p.2 No. 2)
SLI/XFIRE Power Connector
(4-pin SLI/XFIRE_POWER1)
(see p.2 No. 33)
2 4 2 4 2 4
2 4 2 4
ASRock ALiveXFire-eSATA2 Motherboard
This header accommodates
several system front panel
functions.
Please connect the chassis
speaker to this header.
Please connect a chassis fan
cable to this connector and
match the black wire to the
ground pin.
Please connect the CPU fan
4 cable to this connector and
3
2 match the black wire to the
1
ground pin.
Pin 1-3 Connected
3-Pin Fan Installation
Please connect an ATX power
supply to this connector.
Please note that it is necessary
to connect a power supply with
ATX 12V plug to this connector.
Failing to do so will cause power
up failure.
It is not necessary to use this
connector, but please connect it
with a hard disk power connecor
when two graphics cards are
SLI/XFIRE_POWER1
plugged to this motherboard at
the same time.