System Compatibility; Miller Fall Protection Product Groups; Connecting Device - Sperian Miller Twin Turbo Manual De Instrucciones Para El Usuario

3.0 System Compatibility

Miller Self-Retracting Lifelines are designed for use with Miller approved components.
Substitution or replacement with non-approved component combinations or subsystems or
both may affect or interfere with the safe function of each other and endanger the compatibility
within the system. This incompatibility may affect the reliability and safety of the total system.

3.1 Miller Fall Protection Product Groups

A comprehensive fall protection program must be viewed as a "total system" beginning with
hazard identification and ending with ongoing management review. Miller Fall Protection views
its products as a "system within a system." Three key components of the "Miller System" need
to be in place and properly used to provide maximum worker protection.
A. ANCHOR POINT/ANCHORAGE CONNECTOR
The first component is the anchor point/anchorage
connector. The anchor point, also referred to as the tie-off
point, is a secure point of attachment for connecting devices
and must be capable of supporting 5,000 lbs. (22.2kN) per
worker or meet OSHA 1926.502 requirements for a safety
factor of two, such as an I-beam or other support structure.
Anchorage connectors, such as the cross-arm strap and
eyebolt, are sometimes necessary to make compatible
connections between the connecting device and the anchor
point.
B. BODY WEAR
The second system component is the personal protective
gear worn by workers while performing the job. Miller Fall
Protection manufactures full-body harnesses, positioning
belts and body belts for use in specific work environments.
Full-body harnesses are engineered to aid in the arrest
of a free fall and should be worn in all situations where
workers are exposed to a potential free fall. The full-body
harness must be used in conjunction with shock-absorbing
equipment to keep fall forces to a minimum. It is imperative
that the harness be worn properly.
C. CONNECTING DEVICE
The third component of the system is the connecting device. The most important feature
of the connecting device is the built-in shock absorber. Whether the connecting device is a
shock-absorbing lanyard or self-retracting lifeline, they are designed to dramatically reduce
fall arresting forces. Rope, web or cable lanyards being used for fall arrest MUST be used in
conjunction with a shock absorber (i.e., Miller SofStop pack).
Individually, none of these components will provide protection from a fall. Used
properly with each other, they form the "Miller System" and become a critically
important part of the "total fall protection system."
Us er Ins tru ct ion s - Engl is h
5
A
B
C