Product Features - BLACK&DECKER PHV1210 Manual De Instrucciones

90560176 PHV1210 PHV1810.qxd:??????-00 Cir Saw book

Product Features

1. Dust collector
2. Dust container release
button
3. Pivot lock button
4. On/off switch
5. Container door
6. Container door release latch
7. Charger
8. Flip-out brush
9. Dust collector extension
Assembly
Adjusting the dust collector
(fig. A - C)
The dust collector (1) has a brush that can
be folded forward for dusting and upholstery
cleaning.
• The dust collector (1) is stored under the
appliance. To adjust for use, unplug the
appliance from the charger (7).
• Press the pivot lock button (3) and rotate
the dust collector (1) to the required
position.
• Release the pivot lock button (3) to lock
the dust collector in position
• The dust collector can be extended by
pulling the dust collector extension (9) until it
locks into position.
• The extension can be retracted by
pressing the button (10) and pushing the
extension back into the dust collector.
• The dust collector should be returned to
the storage position under the appliance
after use and while charging the appliance.
1/18/10 9:49 AM
A
B
C
4
Page 4
Use
• Before first use, the battery must be charged for at least 24 hours.
• Plug the appliance into the charger whenever power gets low.
Charging the battery (fig. D)
• Make sure that the appliance is switched
off. The battery will not be charged with
the on/off switch (4) in the on position.
• Plug the appliance into the charger (7)
as shown. The charging indicator wil be lit.
• Leave the appliance on charge for at
least 24 hours.
While charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charging indicator will be lit as long as
the appliance is connected to the
plugged-in charger.
WARNING:
Do not charge the battery at ambient temperatures
below 39°F (4°C) or above 104°F (40°C).
Switching on and off (fig. E)
• To switch the appliance on, slide the
on/off switch (4) forward to position I.
• To switch the appliance off, slide the
on/off switch (4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter
to remove dirt; however, in order to keep
the suction force optimized, the dust
container and filters must be cleaned
regularly.
Cleaning the dust container and
filters (fig. F - K)
There are two methods of cleaning the
bowl, a quick empty method and a
thorough clean method.
For the quick empty method use the
following instructions.
• Press the release latch (6) and open the
container door (5) (fig. F).
• Empty the dust container (11).
• Close the dust container door (5). Make
sure that the release latch (6) clicks into
place.
For the thorough clean method use the
following instructions.
D
E
F
5