Optional Accessories; Protecting The Environment - DeWalt DE7023 Traducido De Las Instrucciones Originales

english
Carry Strap
If you purchase the carry strap accessory for
D WALT stands, use the square hole in the metal
e
end to mount the accessory.
Locking Locator Clip (fig. 7)
The locking locator clip (i) keeps the saw from sliding
left or right during cutting operations. To move
the clip, remove saw/bracket assembly, loosen
the screw in the center of the clip, slide it to the
desired position and tighten the screw. You can then
remount the saw/bracket in the new location.
Removing the Saw
Once the mitre saw is fastened to the brackets,
it can be removed by grasping the release levers,
pulling up slightly to clear the beam and can be set
down on the non marring feet for transportation or
cleaning.
Carry Handle (fig. 10)
A handle (h) has been supplied to transport the mitre
saw stand to and from the work site.
WARNING: To reduce the risk of
personal injury, DO NOT attempt to
store the stand with the saw attached.
Loss of control may result.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Cleaning
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
20
Consult your dealer for further information on the
appropriate accessories.
COMPATIBLE PRODUCTS
DE7025
DE7030
DE7024
DE7029
DE7027
DE7028
DE7031

Protecting the Environment

Should you find one day that your D
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
e
recycling of D
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
e
manual. Alternatively, a list of authorised D
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com.
WALT, have
e
be hazardous. To reduce the risk of
injury, only D WALT recommended
e
accessories should be used with this
product.
Mitre saw mounting brackets
Wide mitre saw mounting brackets
Work support/stop
Wide work support/stop
Roller work support
Extension support
Dual leg extension support
Separate collection. This product must
not be disposed of with normal
household waste.
e
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
WALT products once they have
e
WALT product
WALT
e