Installing Support Rods - Sachtler Ace Base Plate Manual De Instrucciones

Installing support rods

Two support rods can be fitted to the Ace Base Plate to accommodate an Ace Follow Focus or
Ace Matte Box if required.
To fit the support rods to the Ace Base Plate (see Fig. 4):
Insert one end of the rod into the support rod housing at the front left-hand side of the
Ace Base Plate, and continue to slide back until it protrudes through the support rod
housing at the rear of the Ace Base Plate [A].
Adjust the support rod to the required position and secure with the support rod clamp [B].
A
Fig. 4 Support Rod Installation
-7-
B
EN EN