Removing The Ace Base Plate; Removing The Camera - Sachtler Ace Base Plate Manual De Instrucciones

Removing the Ace Base Plate

To remove the Ace Base Plate from the head (see Fig. 2):
Ensure that the head platform is level and apply both the pan and tilt brakes.
Loosen the slide plate clamping screw. Pull the Ace slide plate to the rear of the fluid
head whilst pressing the red release button [B].
Whilst holding the camera, slide the Ace Base Plate out to the rear of the platform and
away from the head.
Loosen the camera screws on the Ace slide plate, then remove the slide plate from the
Ace Base Plate.

Removing the camera.

To remove the camera from the Ace Base Plate (see Fig. 6):
Ensure that the head platform is level and apply both the pan and tilt brakes.
Loosen the slide plate clamping screw. Pull the slide plate to the rear of the fluid head
whilst pressing the red release button.
Slide the camera out to the rear of the platform and away from the Ace Base Plate.
Loosen the camera screws securing the Ace slide plate to the camera. Remove the Ace
slide plate from the camera.
Fig. 6 Removing the camera
-9-
EN EN