Craftmade Ellington E-LAV44BP4LK Guia De Instalacion página 6

5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the hanging ball
slot until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit
over the threads on the wood screw. Extra cable slack
can be left in ceiling area.
Continue to "Wiring" section for wiring diagram.
Remove and set aside canopy cover to reveal 6
holes. Notice that 3 of these holes are larger.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph. If
there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Remove pin, clip and set screws from motor
housing yoke. Thread wiring through canopy.
Place canopy over yoke, aligning larger holes in
canopy with the 3 existing screws in top of
motor housing. Insert the 3 screws and 3 lock
washers that had been removed (if there were
only 3 screws located in top of motor housing,
these screws/lock washers will be located in one
of the hardware packs) into the remaining holes.
Securely tighten these screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over the
hanging bracket tab. (Use one of the non-slotted
holes on the rim of the canopy to do so.)
Attach safety cable according to the instructions
in the third paragraph of Section 5 above.
wood
ceiling
joist
canopy
set screw
clip
motor housing
page 5
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
motor
housing
canopy
canopy cover
canopy
pin
yoke
motor housing
canopy
hanging bracket tab