Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A s s e m b l y S t e p 6
Remove the
Screws (#02) and Washers (#79) that are
pre-assembled on the back of the Monitor (#01) as set
them aside as they will be used later in this step.
Connect the Monitor Wire (Upper) (#01a) to the Monitor
Wire (Middle) (#50) and tuck the wires in the hole of the
Center Post (#28) to avoid pinching them.
Attach the Monitor (#01) to the Center Post (#28) by
aligning the holes and securing with four
and four Washers (#79).
Attach the Hand Pulse Bar (#04) by aligning it to the
horizontal catch located on the Center Post (#28) and
secure using one Center Post Shroud (#56R) and T
Shape Bolt (#62). Do not over tighten the T Shape Bolt
(#62) now.
Hardware Required
Bolts
#02. Screw (M4x12 mm) [4 Pieces]
Washers
#79. Washer (d4xФ12x1.0 mm) [4 Pieces]
Others
#62. T Shape Bolt (M8x60x20 mm) [1 Piece]
BRM8981
Assembly Instructions
Screws (#02)
A s s e m b l y S t e p 7
Attach the Center Post Shroud (#56F) over the
Center Post (#28) and Hand Pulse Bar (#04) as
shown below and secure using two Screws (#54) on the
top and one Screw (#55) on the bottom.
Remove the Screws (#75) and Washers (#74) that are
pre-assembled on the Center Post (#28) and set
them aside as they will be used later in this step.
Attach the Water Bottle Holder (#73) by aligning it to
the holes on the Center Post (#28) and secure using
two Screws (#75) inserted through two Washers (#74).
Connect the Hand Pulse Wire (#61) to the hole on the
back of the
Monitor (#01).
Tighten the T Shape Bolt (#62) now.
F
Hardware Required
Bolts
#54. Screw (ST4.2x19Xφ8 mm)
[2 Pieces]
#75. Screw (M4x12 mm) [2 Pieces]
Washers
#74. Washer (d4xφ12x1.0 mm) [2 Pieces]
Note:
Care should be used when mounting or dismounting
the equipment. Before mounting or dismounting,
move the pedal on the mounting or dismounting
side to it lowest position and bring the machine to
a complete stop.
This unit is not equipped with a free-wheel. Pedal
speed should be reduced in a controlled manner.
#55. Screw (ST4.2x25Xφ8 mm)
[1 Piece]
Page 10
Publicidad
Tabla de contenido
