body Power BRM8981 Manual Del Usuario página 7

A s s e m b l y S t e p 1
Remove the Bolts (#51), Washers (#30) and Tubes that
are pre-assembled on the bottom of the front and rear
of the Main Frame (#60) and set them aside. The Bolts
and Washers will be used later in this step. The two tubes
are the packing material to protect the production.
With the help of an assistant, attach the Front Stabilizer
(#18) to the front of the Main Frame (#60) by inserting two
Bolts (#51) through two Washers (#30) and up through
the Front Stabilizer (#18).
Next, attach the Rear Stabilizer (#52) to the back of the Main
Frame (#60) by inserting two Bolts (#51) through two
Washers (#30) and up through the Rear Stabilizer (#52).
Please Note that the Front Stabilizer (#18) has roller
wheels that spin for ease of relocating the unit and the
Rear Stabilizer (#52) has height adjustable caps
for leveling of the unit.
Roller Wheels
(front of caps)
Front
BRM8981
Assembly Instructions
Make sure this wire is exposed and hanging out before proceeding
to the next step. If it has fallen inside the tube, use a
bent wire to "fish" it out.
Rear
Hardware Required
Bolts
#51. Bolt (M8x50x20xS6 mm)
[4 Pieces]
Washers
#30. Washer (d8xφ16x1.5 mm)
[4 Pieces]
Height Adjustable Caps
(bottom of caps w/
side adjustment dials)
Page 6